Startup
Connect the sensor to a PoE switch
Power up the sensor by connecting the LAN/PoE port to a PoE switch that supplies 802.3.at (PoE) power. The LAN/PoE port supports Ethernet speeds up to 100 Mbps. The network connection should support a continuous data rate (streaming) of 50 kByte/s. In a normal use-case the sensor’s data rate is 10-20 kByte/s.
Functional control After connecting the sensor to the PoE outlet power supply will be on. Successful power supply can be visually validated at the sensor: a green LED in the sensor blinks when power is applied and turns off automatically after 15 seconds; the LED remains off in normal operation.
Refer to the Wiring Diagramm for an illustration on a QUMEA RADIQ sensor being connected to a PoE switch.
IP/DHCP/MAC The device receives an IP address from the local DHCP server (or router that functions as a DHCP server) in your network. If your network does not include a DHCP server, contact QUMEA support team to assign the sensor a static IP address. Ensure the sensor is allowed to connect to the internet/the QUMEA Cloud. The sensor’s DHCP name is equal to its serial number (e.g. R1B10123). You find the sensor’s Ethernet MAC address printed on the sensor label to configure your network accordingly. Alternatively you can request a list of all MAC addresses of your sensors from your sales representative. Read the IT Requirements for QUMEA customers section in the user manual for more information on how to configure your network.